THE SYNTHWERKS SLIDE POT FAMILY OF MODULES

The Synthwerks SP-1P

Single Passive Slidepot Module

The has a single 60mm throw high quality linear slide pot with its taps wired to a set of 1/8" jacks. There are no active electronics in the module. The module can pass both AC and DC signals with output levels proportional to the position of the slider. The Jacks and slide pot are mounted to a 8 HP reversible panel. The panel graphics are so that the panel can be rotated to choose if the jacks are above the slide pot (desktop orientation) or below the slide pot (cabinet orientation).


The
SP-1P is 8HP in width and has a MSRP of $75 (US).

BUY THIS MODULE DIRECTLY FROM

The Synthwerks SP-4DP

Quad Dual Slidepot Module

 

The SP-4DP has four 60mm throw high quality dual slide pots with both sets of taps each wired to a set of 1/8" jacks. Opposing end taps on each half of the dual slid pot are normalized to a range-selectable DC control voltage (approximately +5 or +10 volts or Ground). The module can pass both AC and DC signals with output levels proportional to the position of the slider. The Jacks and slide pot are mounted to a 26 HP reversible panel. The panel graphics are so that the panel can be rotated to choose if the jacks are to the left or to the right of the slide pots for left or right handed operation, or for setting two unit side-by-side with 8 sliders together in a group.

 

The SP-4DP is 26HP in width and comes in two versions:

Fully assembled and tested at a MSRP of $225,

and as a DIY Kit version with all parts for a MSRP of $150.

 

BUY THIS MODULE DIRECTLY FROM

Synthwerks is proud to be a member of
the Mostly Modular Trade Association.

HOME | PRODUCTS | CONTACT